The Tektronix 371A Curve Tracer is the world standard for high resolution curve tracers and is used in a wide variety of applications. This Curve Tracer performs DC parametric characterization of thyristors, SCRs and power MOSFETs. The high voltage collector mode permits testing the Off-characteristics of a device up to 3,000 volts. The pulsed high current collector mode provides output current pulses greater than 400 amps peak for testing On-characteristics. It also permits high power testing up to 3,000 watts. In the R&D lab, the Tektronix 371A Curve Trace is used for characterization of new designs, extraction of SPICE parameters, failure analysis and data sheet generation. In manufacturing test, it is used to verify device quality and process monitoring. The Tektronix 371A Curve Tracer is used for incoming inspection to verify device performance, perform failure analysis and to match components.
Features and Specifications of:
oApplications
●Manual or Automated High Resolution DC
●Parametric Characterization of Semiconductors
●Incoming Inspection
●Manufacturing Test
●Process Monitoring and Quality Control
●Data Sheet Generation
●Component Matching
●Failure Analysis
●Engineering
oHigh Power Measurements of Semiconductor Devices
●Up to 3,000 Volts
●Up to 400 Amps
●Up to 3,000 Watts
oWaveform Comparison
oEnvelope Display
oWaveform Averaging
o3.5 inch MS DOS Compatible Disk Storage
■Fully Programmable
●Interactive Programmable Control: from the full featured front panel or over the GPIB
ooperating parameters can be adjusted and stored
ooperating parameters can be recalled:
●via 371A nonvolatile memory
●via built-in MS DOS-compatible floppy disk
●via an external controller
■3 Cursor Measurement Modes
oDot Cursor: provides direct screen readout of voltage, current, gm or DC beta at any point
oWindow Cursor:
●can be positioned between two curves to measure small signal beta or gm
●can be used for visual go/no-go tests
oFunction Line Cursor: provides screen readout of a slope or intercept value
■Sweep Measurement Mode
oprovides for automatic construction of a family of curves while stimulating the device with low duty-cycle pulses
oprovides power curves to be displayed without excessive heating of the device
■Test Fixture:
ostandard accessory
oprovides safe device enclosure to ensure operator protection during measurements
oKelvin Sense Measurements
oadapter accommodation:
●standard A1001-A1005 adapters with Kelvin sensing
●3-Pin adapters without Kelvin sensing
●A1023 and A1024 surface mount adapters
Other Curve Tracers
■Agilent B1505A
■Tek 370B
